Do not exceed the manufacturer’s load specifications. Never overload a scaffold with materials or people as per section 126(3) of O.Use a ladder to access the work areas of the scaffold tower.When guardrails cannot be installed on the scaffold, use appropriate fall protection equipment when working off scaffold (as required by section 26(3) of O.Use appropriate fall protection during the erection and dismantling of the scaffold (as required by section 125(2) of O.Overhead power lines should be de-energized or insulated by the local utility company.Observe regulated limits of approach around live electrical wires and equipment.Always check for overhead power lines before moving any scaffolds.Minimum distance from live power lines for electricity Voltage of live power line When erecting scaffolding near power lines stay outside the limits of approach as required by section 188 of O.Overhead dangers should be identified and controlled.All towers should be plumbed and levelled.If the height of the scaffolds exceed 15 metres for frame scaffold or 10 metres for tube and clamp scaffold, the scaffold shall be designed by an engineer and erected according to the design (as per section 130(1) of O.If the height exceeds three (3) times the least lateral width, the scaffold tower must be secured to a suitable structure or the tower should be braced using guy wires or other suitable support. The total working height of a freestanding scaffolding tower should be three (3) times the distance of the narrowest side of the base (if this is a measurement of outriggers, they must be set symmetrically about the tower). Safety takes precedence and includes the following: 213/91).įollow the manufacturer’s instructions and replace any damaged components. Scaffolds shall be inspected before use and after any modifications (as per section 130(3) of O. This includes inspecting equipment before assembly. The erection and dismantling procedures are to be conducted by qualified technicians. Tab to close the table of contents and return to the book. Appendix F: Ministry of Labour, Training and Skills Development Occupational Health and Safety Branch contact information.Appendix A: Department heads (as per safety responsibilities and duties).43: Industrial and construction regulations 33: Working In extreme temperature conditions 32: Water locations, small craft/vessel and at dockside 30: Underwater stunts and underwater operations 18: Camera cars: process trailers and towed vehicles 14: Seat belts, harnesses, roll cages and air bags in vehicles 3: Communication regarding potentially hazards procedures
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |